73-87chevytrucks.com

News:

73-87ChevyTrucks.com offers select, high quality parts for sale that help fund this website and Forum. Take a moment to drop by The Store and shop our products. If you don't find what you're looking for, shoot us an email (webmaster@73-87chevytrucks.com) - the part simply may not have been added yet. We add new items all of the time.

Welcome to 73-87chevytrucks.com

73-87chevytrucks.com is not only a forum we are also a vendor for a variety of parts both replacement and custom. Check out our store at 73-87chevytrucks.com Online Store

73-87chevytrucks Social Network

We are also on Facebook so give us a like to the page if you like what you see: http://www.facebook.com/7387chevytrucks

73-87chevytrucks Merchandise

SpreadShop Site

Cafepress Site

87 R10 dual tank pump issue and hot fuel module

June 08, 2026, 10:16:13 am by Ocho | Views: 183 | Comments: 0

I'm doing an LS swap on my truck with carburetor. I'm using the factory dual tank setup with the selector switch and fuel pump relay as original. But I'm bypassing the solenoid valve for the fuel selection Only , it's still being used for the fuel gauge readings. Here's my issue, and I'll include a picture. On my bulkhead connector there's a terminal that comes out with two tan wires. One goes to the fuel take selector switch on the dash and the other wire goes straight to the left fuel pump. This terminal activates with key on. Therefore, energizing the left fuel pump and eliminating the ability to use the tank selector switch on the dash. Question is, should there be two wires coming out of this terminal? Because I can't find any wiring diagrams that show two wires coming out. My other concern is perhaps this feeds to the hot fuel moduleal and it is defective, therefore allowing voltage to pass through the module and straight to the left tank. Been chasing this for a few days so any help is very appreciated

Read More | Write Comment

Help with C10 Short Box Front Tire Size

May 21, 2026, 02:35:49 pm by bshrubb
Views: 2735 | Comments: 6

Hi everyone, I’ve got a 1980 Chevy C10 short box 2wd. I’ve had it for over 20 years and this will be the first time putting front tires on it. It’s at stock ride height for now and I’m running the 8” stock steel rallye wheels. I’ve got a good set of 275/60 bfg radial ta’s on the back. I’m looking for advice on what front tire size would best compliment those rears and give the truck the best look. Any help would be appreciated.
Thanks in advance!

Read More | Write Comment

Cruise control speeds up

May 21, 2026, 12:10:29 pm by GrumpyRetiredGuy | Views: 2809 | Comments: 1

1987 R10 350/700R4

After replacing the control arm on the steering column I was happy to see the cruise control works on this old girl. The issue is it will not maintain a steady speed on a flat straight road. The speed creeps up as I'm driving. Any suggestions on what to check would be great. Thanks in advance and happy wrenching.

Read More | Write Comment

Option to “thumbs up” a post

May 13, 2026, 10:37:49 pm by philo_beddoe
Views: 4862 | Comments: 2

Similar forums I am on with the same platform have the option (next to the quote button) to give a thumbs up to the post. Chris, can you add this? If someone likes a post they can just hit the thumbs up instead of a full reply. Thanks..

Read More | Write Comment

Kick Panel Vent Delete

May 08, 2026, 07:27:20 am by buter1ma | Views: 6852 | Comments: 5

Morning All,

Anyone know anyone out there that is selling a kick panel vent delete kit? I want to seal up the opening and just put a plastic piece over it.
Thanks for the help.

Read More | Write Comment

Pages: [1]