1
Engine/Drivetrain / Re: 357 (350 - .40 Over) Build Questions Etc
« Last post by Mike81K10 on May 06, 2024, 08:00:54 PM »Thanks for clarifying why!
I have never used aluminum heads before nor guide plates. My prior engines were Gen I flat tappet cam engines with iron heads. I am learning some new things with this engine build that I did not know prior. My prior build was easier to deal with and this one is becoming much more expensive.
I have never used aluminum heads before nor guide plates. My prior engines were Gen I flat tappet cam engines with iron heads. I am learning some new things with this engine build that I did not know prior. My prior build was easier to deal with and this one is becoming much more expensive.