|
Welcome to 73-87chevytrucks.com73-87chevytrucks.com is not only a forum we are also a vendor for a variety of parts both replacement and custom. Check out our store at 73-87chevytrucks.com Online Store 73-87chevytrucks Social Network We are also on Facebook so give us a like to the page if you like what you see: http://www.facebook.com/7387chevytrucks Follow us on Instagram at https://www.instagram.com/7387chevytrucks Follow us on Twitter at https://twitter.com/7387chevytrucks 73-87chevytrucks Merchandise Looking for a shirt, cap hoodie or anything else with our logo, check out or Cafepress site or our Spreadshirt siteJanuary 22, 2025, 08:38:44 PM by mamaya3367 | Views: 627 | Comments: 3
Hello Everyone, I have a 1986 Chevy K10/350. Pulled out the engine to rebuild or replace. I need some help decoding the engine. Here is the info and what I was able to dig up. Any help would be greatly appreciated. Cast #4088548 = Small Block V8 1986-1988 350, 2 bolt ID: V0714 URM = flint/july/14th. URM = ? VIN: CGJ184093 CGJ=?? 184093 = Match the last digits of the Truck Vin tag January 17, 2025, 09:10:21 PM by slideways | Views: 1019 | Comments: 6
Im closing in on finishing my 83 K10 and of course it has the big dummy fuel gauge and no tach. I'd like to upgrade to the tach but i dont want to go digital or spend $800 on gauges. I am totally clueless with electrical and scared of the printed circuit deal but it almost seems like the tach conversion kit is the safest way to go. I thought about doing the modified Autometer setup or the glowshift deal but adding and butchering wiring doesnt seem wise to me. I'd like to get a Painless kit eventually also and having it all neat would be nice. What is the nicest and cheapest way to accomplish this? My oil pressure needle broke and the coolant gauge has been swapped and hacked in with a harbor freight one so i'd basically need all of the gauges except amps. My last question is if i have to change back to OEM coolant gauge what is the sender wiring for that? Does it work through the spiral wound sender wire i'm using with the $15 aftermarket gauge or would i have to retrofit more stuff back to make it stock again? Thanks December 29, 2024, 09:32:32 AM by mrghostwalker
Views: 651 | Comments: 2 Does anyone have a Dashmate AM/FM/8 track in their Square Chevy? I believe they were made by Sears. I was wondering if they fit without modification. 1983 Chevy K10/20 Pages: [1]
|
Re: New truck in the drive by Dr_Snooz
[January 25, 2025, 11:59:06 PM] Re: Need Engine VIN Help by mamaya3367 [January 24, 2025, 10:46:11 PM] Re: Air blows sometimes, most times it doesn't by bd [January 24, 2025, 02:20:43 PM] Re: Air blows sometimes, most times it doesn't by juancano [January 24, 2025, 01:59:32 PM] Re: Clunk when hitting bumps after new wheels and alignment by juancano [January 24, 2025, 01:28:27 PM]
|