73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Engine/Drivetrain => Rear Drivelines, Drive Axles and Gearing => Topic started by: buter1ma on December 22, 2019, 01:15:37 PM
-
I have a 86 C10 long bed with two piece driveshaft. I am going to swap in a 700R4. Will I need to go to a one piece or what length from trans to center support bearing do I need?
-
depending on what trans/tail shaft you have now you may or may not have to do anything
(http://forum.73-87chevytrucks.com/smforum/index.php?action=dlattach;topic=37791.0;attach=51451;image)
-
Its is a three on the tree manual transmission. I believe the length will have to change.
-
I doubt your 3-speed is 30" long, but I have seen some with a long tail section.
Is the output shaft the same in size/splines? May not be...
-
Use this website as a tool and to find an inexpensive option. Use a one piece shaft.
http://www.car-part.com/cgi-bin/search.cgi