Technical Forum (Read Only) > Instrumentation

Temperature Sending Unit

<< < (2/2)

sbailey05:
The connector to the sending unit was cut off/broken off so it was just a wire. However, it appeared to be the same blade end but I didn't measure them or really look to make sure they were the same size since the threading didn't fit and the wiring end/connector wasn't present.


Vile, Will do. Gonna get back on it tomorrow. Thank you!

sbailey05:
Well finally got around to finding a place that had one of these. Turns out Autozone had a Duralast TU66 for an 87 that turned out to put the needle slightly before the middle of the gauge at 200-205 degrees(infrared thermometer). The old sending unit has a part number but I forgot to measure the new one and check the resistance before putting it in. The one that came out of the truck was part # AC127CM or I believe ACDelco Part 25037176. Seems to be working just fine and finally solved my problem.

Navigation

[0] Message Index

[*] Previous page