1
Instrumentation / Re: Another gas gauge/ speedo question.
« Last post by Jimartina on Today at 12:49:17 PM »OK so new problem. I installed the new sending unit in the tank. It works. Kind of. It shows just over 1/4 full when the tank is full and it won't move til it gets to a quarter tank then it works properly. I tested it in the tank and out the tank. Did I just get a faulty unit? I know the gage will go to full because if the wires are disconnected it defaults to full. Any input is appreciated
Sent from my SM-S901U using Tapatalk
Sent from my SM-S901U using Tapatalk