collapse collapse

* Who's Online

  • Dot Guests: 155
  • Dot Hidden: 0
  • Dot Users: 4
  • Dot Users Online:

* Board Stats

  • stats Total Members: 21128
  • stats Total Posts: 310064
  • stats Total Topics: 33931
  • stats Total Categories: 8
  • stats Total Boards: 84
  • stats Most Online: 3053

* Recent Topics

* Calendar

October 2022
Sun Mon Tue Wed Thu Fri Sat
1
2 3 [4] 5 6 7 8
9 10 11 12 13 14 15
16 17 18 19 20 21 22
23 24 25 26 27 28 29
30 31

* Search


* Top Boards

Welcome to 73-87chevytrucks.com

73-87chevytrucks.com is not only a forum we are also a vendor for a variety of parts both replacement and custom. Check out our store at 73-87chevytrucks.com Online Store

73-87chevytrucks Social Network

We are also on Facebook so give us a like to the page if you like what you see: http://www.facebook.com/7387chevytrucks

Follow us on Instagram at https://www.instagram.com/7387chevytrucks

Follow us on Twitter at https://twitter.com/7387chevytrucks

73-87chevytrucks Merchandise

Looking for a shirt, cap hoodie or anything else with our logo, check out or Cafepress site or our Spreadshirt site

September 30, 2022, 09:41:51 AM by kpurser | Views: 50 | Comments: 1

1978 K20 with a single 20gal tank. Should be an original-ish system with a quadrajet carb. Fuel lines were so old and brittle they cracked and I had fuel dripping everywhere. Dropped the tank to replace everything and I'm now looking for the piece on the center outlet. Plastic vent piece maybe....high pitch voice. I don't know what it is and am looking through parts sights without success.
September 30, 2022, 06:17:45 AM by buzzman351 | Views: 129 | Comments: 6

I have set timing, replaced map, coolant sensor, egr, pcv, plugs, wires. the list goes on. it runs good but honestly id like for a mechanic to hook it up to a diagnostic machine and tune it or whatever needs to be done. is that possible?
JohnnyPopper
September 27, 2022, 11:50:32 PM by JohnnyPopper
Views: 225 | Comments: 7

Well, I think the time has come to let this Ginny go.

Cleaned her up, submitted to BaT.

Any thoughts on a reserve price?

Thanks in advance!!!

JP
September 27, 2022, 07:32:47 PM by Hubcap706 | Views: 102 | Comments: 1

I have been searching for wheels for my 1979 C10 build for sometime now and have done a ton of research on the forums, but I have not been able to find much information on the attempt that I am trying to make. I really am looking for a good lok and good stance. I want a wheel flush with the fender, slightly able to tuck and I am not looking for a dished look either.

I have a 1979 C10 LWB, coil over suspension in the front with tubular control arms and a flip kit in the rear. I have tossed around the US Mag Ramblers but have made a decision to run the Detroit Steel Delrays instead. In choosing these wheels I have 3 setups that I can run with a range of backspace - 20x9 on all 4, 20x9 front and 20x11 rear, or 20x11 on all 4 and I really want to run the 20x11 on all 4, and I know that the front is going to be the problem area.

Has anyone had any luck in doing so with a similar setup? If so, what backspace? Also, any information on a 10" wide wheel would be appreciated as well.

I have seen one C10 on the 67-72 site that was successful at this and is running 315 tires on all 4 as well. The other 73-87 that is running 11" wide on all 4 is on customwheeloffset.com, however I cant reach out to the owner to see how his clearance is and what his setup is.

Any help is greatly appreciated!! Thanks.
September 26, 2022, 05:40:51 AM by buzzman351 | Views: 120 | Comments: 3

I have been replacing components lately and have seen the posts on how to check for codes but i have no check engine light. i actually reached up behind the cluster and it feels that where the CEL should be is just a plug. any ideas?
Pages: [1]

* Recent Posts

Re: 1985 C10 volt gauge question by bd
[October 03, 2022, 03:13:42 PM]


Re: 1985 C10 volt gauge question by recoil
[October 03, 2022, 02:01:26 PM]


Re: 1985 C10 volt gauge question by bd
[October 02, 2022, 07:27:36 PM]


Re: I found a hood, a real one. by JohnnyPopper
[October 02, 2022, 07:05:38 PM]


Re: I found a hood, a real one. by VileZambonie
[October 02, 2022, 06:27:41 PM]

* Top Poster

VileZambonie VileZambonie
18613 Posts
Captkaos Captkaos
18200 Posts
Irish_Alley Irish_Alley
13319 Posts
zieg85 zieg85
7462 Posts
bd bd
6202 Posts

* Forum Staff

admin Toolmaster
Administrator
Captkaos admin Captkaos
Administrator
roundedline admin roundedline
Administrator
ccz145a gmod ccz145a
Senior Member
zieg85 gmod zieg85
Senior Member
gmod Judge Roy Bean
Site Supporters
N2TRUX gmod N2TRUX
Global Moderator
gmod roundedline1
Private
gmod realsquash
New Users
Irish_Alley gmod Irish_Alley
Global Moderator
VileZambonie gmod VileZambonie
Global Moderator
Blazin gmod Blazin
Global Moderator
bd gmod bd
Global Moderator
bajaburban lmod bajaburban
Newbie
lmod red4wd
Registered Users