Registration and Posting Agreement
Beastie-You didn't discuss it, but there is an adjusting ring that is supposed to be replaced with the upper ball joint. They are a matched pair. Refer to #300 on Vile's parts diagram. The adjusting sleeve is supposed to be packaged with the upper ball joint when you buy the parts. Just curious if you replaced it and just forgot to mention it.Manual says not to touch it unless alignment is off.Also, the six 9/16" nuts you mentioned: Did you replace those? I thought they were cone nuts and one-time use only. When I did mine, I wasn't aware of this but I reinstalled them with some red Loctite and never had a problem.The six 9/16 nuts, I did not replace, not needed. You are thinking of the 3 nuts on the top of the steering arm which need to be replaced. I used red loctite on the six nuts because they only get tightened to 120in/lb.