« previous next »
Pages: 1 ... 9 10 [11]   Go Down

Author Topic: project onion rings  (Read 23472 times)

Offline chevn-up

  • Registered Users
  • *
  • Posts: 151
  • Newbie
Re: project onion rings
« Reply #150 on: April 11, 2023, 03:51:42 AM »
same size, single row...29x20 core, overall length 33 1/2. plastic ends. Took a little searching the net to find. Matches the rubber bushings and upper brackets also.
Logged

Offline chevn-up

  • Registered Users
  • *
  • Posts: 151
  • Newbie
Re: project onion rings
« Reply #151 on: April 30, 2023, 10:03:12 AM »
Installed the front side lines of the cooler. Used NBR hose. Should be ok.
Logged

Offline chevn-up

  • Registered Users
  • *
  • Posts: 151
  • Newbie
Re: project onion rings
« Reply #152 on: April 30, 2023, 10:07:28 AM »
Also, finished with the front wire harness. All new bulb sockets. Everything soldered, as well as dielectric grease and shrink-wrap on all splices. Pert near new again.
Logged

Offline chevn-up

  • Registered Users
  • *
  • Posts: 151
  • Newbie
Re: project onion rings
« Reply #153 on: April 30, 2023, 10:08:50 AM »
Now to start on these.
Logged
Pages: 1 ... 9 10 [11]   Go Up
« previous next »