73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Engine/Drivetrain => LT/LS Swaps => Topic started by: jfkelley on January 28, 2023, 11:02:34 PM
-
Hello All ..I just installed my 5.3 / 4l60e into my 76 K10 4x4 ..I placed my Dirty Dingo Motor mounts 1/2” forward front the most rearward position this should be about the factory bell housing position as specified ..But by the looks of it my NP241C transfer case is going to be too far back to where the shifter might be up against the seat or in the seat .. any ideas ?
-
Make sure the base plates are on their respective sides and forward facing. If you aren't achieving the proper location with all that adjustability I would suspect you have them on wrong.