Recent Posts

Pages: 1 2 [3] 4 5 ... 10
21
Engine/Drivetrain / Re: 357 (350 - .40 Over) Build Questions Etc
« Last post by Mike81K10 on April 29, 2024, 10:25:34 AM »
Don't know yet!
22
Members Rides / Re: 1986 C10 after 14 years finally started on
« Last post by Shifty on April 29, 2024, 09:36:47 AM »
heck ya Zeig!   8)
23
Engine/Drivetrain / Re: 357 (350 - .40 Over) Build Questions Etc
« Last post by Shifty on April 29, 2024, 09:32:15 AM »
Looks good Mike!  Do the valve covers clear the power brake booster?
24
Engine/Drivetrain / Re: No vac dizzy
« Last post by Chevygold on April 29, 2024, 09:30:17 AM »
Pretty sure FO is good, I checked double checked and then checked again just to be sure but will look again, one thing I noticed was all was good at first start but after running for 5-10 minutes the dancing tacho started again, above 2500 it's steady again then back to idle and back to its tricks again.

Graham
25
Engine/Drivetrain / Re: Something is scrapping the driveshaft!
« Last post by Shifty on April 29, 2024, 09:29:54 AM »
Aww man!  Why did you remove your roadkill-scraper-mount?  ;D
26
Body, Glass & Paint / Re: Cab floor brace support
« Last post by philo_beddoe on April 28, 2024, 10:31:56 PM »
Quote from: VileZambonie on December 04, 2022, 08:52:13 AM
Take out inner fender, loosen body mounts, jack up cab, cut, drill, grind, repair, patch, & weld all associated parts, lower cab, measure shim, adjust. Use rust protection on all areas. Should only take like 5-10 minutes.  8)
Well, two years later,,,finally got around to replacing that cab floor brace,,, sort of. Turns out the rotted section never reached the cab mount. So we cut out the bad section and welded in the exact shape piece needed, trimmed and painted. Done!
27
Engine/Drivetrain / Re: Something is scrapping the driveshaft!
« Last post by philo_beddoe on April 28, 2024, 10:24:08 PM »
Well I unriveted that useless box, gone! Cleaned the area and painted. Looks like it was never there. Will add pic when I get a chance.
28
Interior & Equipment / Re: 1987 R10 Silverado RPO decoding
« Last post by zieg85 on April 28, 2024, 09:34:48 PM »
My sticker in my glovebox gives me that code.  It also is different with the trim levels
29
Interior & Equipment / 1987 R10 Silverado RPO decoding
« Last post by mcgarijs on April 28, 2024, 09:13:38 PM »
trying to get new interior and not sure if it had black or charcoal velour originally. looking for RPO codes for either black or charcoal , door panels, velour seat, velour inserts in the all electric door panels as well as the ceiling. I have found a partial RPO codes but not one that breaks down the interior options.
Thanks in advance.
30
Engine/Drivetrain / Re: 357 (350 - .40 Over) Build Questions Etc
« Last post by VileZambonie on April 28, 2024, 06:59:51 PM »
4 bolts are fine as long as you aren't doing anything crazy. It's coming along!
Pages: 1 2 [3] 4 5 ... 10