Headers

[vervepipes]

So I was at the pick n pull and found a set of headers on a 350 and snatched them up right away before realizing one critical point: these were on an '88+ model, headman model 69440.  Is there any interferance frame wise or other interferance that will keep me from installing these?  I am about half done sand blasting them to prep for paint, and am wondering if I should just sell them or if they will fit.  Thanks!

[beastie_3]

They wont bolt up to your existing exhaust. If they are short tube, you might not have problems, but you probably will if they are long tube.

[vervepipes]

I'm not re-using any of the old exhaust at all, it is all too far gone to be salvaged

[Irish_Alley]

they should work. test fit them now see if you have to bend them, then bend them and paint