73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Engine/Drivetrain => LT/LS Swaps => Topic started by: nighthawker5 on October 01, 2017, 01:22:10 PM
-
So I'm hooking up the starter and I torqued the nut on the starter switch wire and broke the stud. I got the solenoid off but can't see if there's a way to get the stud out. Any suggestions? I know these are cheap but I'm mad I torqued it too hard.
Thanks
-
Probably an easy out is going to be your best bet... but you might spend about as much on a new solenoid
Sent from my iPhone using Tapatalk
-
If you don’t already have the right size easy out or know someone who does at leazt
Sent from my iPhone using Tapatalk
-
The machine screw comes out from the back side of the plastic cap. Don't try to repair the solenoid. It isn't worth the trouble. Either replace the complete starter or, if money is tight, just the solenoid.