Author Topic: Power Torque Industries gear splitter?  (Read 3079 times)

Online zieg85

  • Global Moderator
  • Senior Member
  • ****
  • Posts: 7543
    • 73-87 GM squarebody extended cab and conversions up to 91 R/V series
Power Torque Industries gear splitter?
« on: December 28, 2011, 10:17:57 PM »
Does anyone have any personal experience with a Power Torque Industries 2XT gear splitter.  Not much info out on these except a YouTube video and a few other mentions on the internet.  I found one locally and am going to see it tomorrow.
Carl 
1985 C20 Scottsdale 7.4L 4 speed 3.21
1986 C10 under construction
https://www.facebook.com/groups/248658382003506/

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: Power Torque Industries gear splitter?
« Reply #1 on: December 29, 2011, 12:53:55 AM »
     You are talking about the splitter that goes between the bell housing and transmission correct ?  Your truck is auto right, which will make the installation a little easier.
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Online zieg85

  • Global Moderator
  • Senior Member
  • ****
  • Posts: 7543
    • 73-87 GM squarebody extended cab and conversions up to 91 R/V series
Re: Power Torque Industries gear splitter?
« Reply #2 on: December 29, 2011, 10:09:04 AM »
     You are talking about the splitter that goes between the bell housing and transmission correct ?  Your truck is auto right, which will make the installation a little easier.

Yes that is the splitter I am referring to.  And no this is for my 85C20 with the SM465 in it.
Carl 
1985 C20 Scottsdale 7.4L 4 speed 3.21
1986 C10 under construction
https://www.facebook.com/groups/248658382003506/