Author Topic: Fleetside rear wheel tub extension  (Read 1341 times)

Offline kcwis

  • Newbie
  • Posts: 65
  • Newbie
Fleetside rear wheel tub extension
« on: July 15, 2019, 12:23:10 PM »
Looking for a source for the approx 8 x 10 inch square sheet metal piece that attaches to the rear of the wheel tube and goes down and attaches to the inner wheel arch to stiffen up the rear lower fender,I don't want to instal a round rod brace like the stepsides have,(1976 GMC 2wd 1/2 ton) tried but could not upload picture,too large ?

Offline haroldwca

  • Newbie
  • Posts: 84
  • Newbie
Re: Fleetside rear wheel tub extension
« Reply #1 on: August 02, 2019, 08:07:38 PM »
The piece you seek is a part of the "Rear Inner Wheel House" (see Store, this forum).  It is the inner wheel lip on the bedside.  The piece you are looking for (as was I about a year and a half ago) does not seem to be sold separately, although it typically is the only part of the bedside that needs attention around here (SE NC, USA).  It is the extreme lower end of the Rear Inner Wheel House. 

Offline kcwis

  • Newbie
  • Posts: 65
  • Newbie
Re: Fleetside rear wheel tub extension
« Reply #2 on: September 20, 2019, 08:42:01 PM »
I found some!
« Last Edit: September 20, 2019, 08:51:29 PM by bd »