Author Topic: LS Gurus Question  (Read 974 times)

Offline jfkelley

  • Newbie
  • Posts: 81
  • Newbie
LS Gurus Question
« on: January 28, 2023, 11:02:34 PM »
Hello All ..I just installed my 5.3 / 4l60e into my 76 K10 4x4 ..I placed my Dirty Dingo Motor mounts 1/2” forward front the most rearward position this should be about the factory bell housing position as specified  ..But by the looks of it my NP241C transfer case is going to be too far back to where the shifter might be up against the seat or in the seat .. any ideas ?
« Last Edit: February 02, 2023, 08:37:23 PM by jfkelley »
1976 Chevrolet Scottsdale 4x4 ,K10 33” BF Goodrich All-Terrain .. in the middle of an LS swap LM7/4l60e/NP241C

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 18980
Re: LS Gurus Question
« Reply #1 on: January 29, 2023, 07:16:10 AM »
Make sure the base plates are on their respective sides and forward facing. If you aren't achieving the proper location with all that adjustability I would suspect you have them on wrong.
,                           ___ 
                         /  _ _ _\_
              ⌠¯¯¯¯¯'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10