TODAY is a Great Day to visit our Store and order the parts you need for your truck!
Do you have them out on a table and comparing the length side by side?
Lay a straightedge along the valve stem tips to see whether they are all the same height.
Quote from: zieg85 on February 01, 2019, 02:05:39 PMDo you have them out on a table and comparing the length side by side?Laid out pushrods on a table and put straight edge across both ends.They are about as dead nuts equal li length as that method can measure.Also placed a straight edge across the valve stems and they too are even.
So a 'wobble' would indicate the stud is bent, yes? And you said the machine shop supplied them? Take them out and place against a straight edge and replace as needed. But how did they get bent???