Author Topic: Rear A/C fan housing for '89 Suburban  (Read 6347 times)

Offline skylark68

  • Newbie
  • Posts: 12
  • Newbie
Rear A/C fan housing for '89 Suburban
« on: May 10, 2012, 04:37:32 PM »
The rear A/C on my Suburban works fine, but the fan motor housing is cracked and the fan rubs badly even on low. I've looked and looked, but can't find a source online for a replacement. I tried to pop rivet it back together and it held for a little while but then the fan started rubbing again. It's cracked and broken where the bolts hold the upper and lower assemblies together. I guess at one time someone working on the Suburban was rough with it. Any ideas on where I could find one? I guess if nothing else I can start looking in junkyards.
« Last Edit: May 14, 2012, 04:29:13 PM by skylark68 »

Offline bake74

  • Senior Member
  • ****
  • Posts: 5871
    • Build Thread
Re: Rear A/C fan housing
« Reply #1 on: May 12, 2012, 12:44:43 PM »
     If you have no luck on line, I would try a pick-n-pull type first, they will be cheaper than say a full on recycle yard.
#1: The easiest and most obvious solution to any problem is 99% of the time correct.
#2: There is no such thing as impossible, it just takes longer.
  74 k10, 77k10    Tom

Offline skylark68

  • Newbie
  • Posts: 12
  • Newbie
Re: Rear A/C fan housing
« Reply #2 on: May 14, 2012, 04:28:37 PM »
Thanks, that's a good idea. I'll probably start hunting this weekend. It's getting hot quick here in Texas and that rear A/C really helps out when it's working.

P.S. Does anyone know how the upper assembly is bolted to the ceiling of the cab? I never took it that far apart.

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18351
    • http://www.73-87chevytrucks.com
Re: Rear A/C fan housing for '89 Suburban
« Reply #3 on: May 21, 2012, 12:56:15 PM »
Should be bolted into the roof ribs.

Offline BlackTomC

  • Registered Users
  • *
  • Posts: 143
  • Newbie
Re: Rear A/C fan housing for '89 Suburban
« Reply #4 on: September 08, 2015, 12:12:11 PM »
Curious to know, how'd this all turn out? I'm currently refurbishing/fiberglassing the new housing and trim piece for the rear AC and have ALL the components to make it work (all removed by myself).
The bottom line has dropped

Offline BlackTomC

  • Registered Users
  • *
  • Posts: 143
  • Newbie
Re: Rear A/C fan housing for '89 Suburban
« Reply #5 on: October 13, 2016, 07:48:54 PM »
Decided to plastic weld my cracks and vinyl wrap it, looks el primo
The bottom line has dropped

Offline dropped74

  • New Users
  • Posts: 1
  • Newbie
Re: Rear A/C fan housing for '89 Suburban
« Reply #6 on: December 08, 2019, 01:09:50 PM »
Mine is not cracked but does rub. Could this just be because the inside housing has rattled lose and needs to be tightened up?


Sent from my iPhone using Tapatalk