Registration and Posting Agreement
I'm attaching photos of what I'm dealing with, and the tools I plan to use as I've never tapped a bolt before and want to ensure I don't make a mistake.1. The snapped bolt is a clean snap. The surface is flat, and is about 1/2'' deep into the block.2. I'll punch the center with a nail.3. Drill a small pilot hole with a 1/8'' metal bit.4. Use a tap that's designed for 5/16'' - 3/8''5. And hopefully be on my way.Also, my service manual shows there is a 3rd bolt with a bracket that should be in place... I've never had this bracket. Any personal recommends on a vendor to purchase one?