73-87chevytrucks.com

Welcome to 73-87chevytrucks.com

73-87chevytrucks.com is not only a forum we are also a vendor for a variety of parts both replacement and custom. Check out our store at 73-87chevytrucks.com Online Store

73-87chevytrucks Social Network

We are also on Facebook so give us a like to the page if you like what you see: http://www.facebook.com/7387chevytrucks

73-87chevytrucks Merchandise

Cafepress site

Spreadshirt site

Need advice for 86 1/2 ton K10

April 12, 2024, 05:20:21 AM by louder50 | Views: 113 | Comments: 4

I bought an 86 1/2 ton K10 with no drivetrain other than the front and rear 3.43 axles. It came originally with a v6 and 4 speed manual trans. I have a rebuilt 350 to install but I don't know what to do about a trans and transfer case. I'd like to be able to drive it on the freeway and am thinking a 700r4 would be good. I'm not off roading it just a year round driver in Michigan. If I put a 4 speed manual back in it I don't think it would be good on the freeway but am I wrong? What would I need for 700r4 swap?

Read More | Write Comment

1987 R10 Silverado L03 305 TBI with a 42 code

April 11, 2024, 09:39:48 PM by mcgarijs
Views: 77 | Comments: 1

Engine stumbles randomly at highway speeds and at Idle. A code 42 is stored. When the codes are clear the engine runs smooth. But will randomly every 5 to 10 min stumble. if at idle it may actually die and has to be restarted. I don't have an oscilloscope to check square waves as I read in a troubleshooting guide. The previous owner may have been chasing the same problem. I have receipts from the dealer Capital Chevrolet in Austin Tx. they took it to and replaced both fuel tank pumps, selector valve, tank selector switch both TBI injectors,distributor,ignition coil, TStat, Alternator, IAC valve. Will start and run just fine but will randomly stumble has me puzzled.

Read More | Write Comment

Site Cert

April 11, 2024, 07:04:06 AM by alfreema | Views: 79 | Comments: 2

Any particular reason the forum doesn't have a free letsenrcypt SSL cert? Browsers are very picky these days about having a cert, and I would think in this day and age not having a cert would kill the ability for people to register or access this site? I also think you get dinged tremendously in SEO for not having a cert.

Read More | Write Comment

Source for 1976 radio connectors

April 10, 2024, 07:49:46 PM by alfreema | Views: 180 | Comments: 9

I have the following two connectors for my bone stock '76 AM radio ...

Power

Speaker

And I want to tie in a bluetooth amp that I bought. But I don't want to cut/splice/replace my original connectors or wires. I'd like to find a male version of the power and speaker connectors (or maybe those are the males and I need females -- I didn't really pay attention to what was going into what when I pulled them).
I am having a terrible time finding anything that would work that would let me not modify the OEM stuff.
Help??
Thanks a ton in advance!
https://imgur.com/bwJgWTvhttps://imgur.com/bwJgWTvhttps://imgur.com/bwJgWTv

Read More | Write Comment

Exhaust System for New Engine

April 09, 2024, 02:46:41 PM by Mike81K10
Views: 178 | Comments: 8

I am going to have a new engine and will install headers. I will need a new exhaust system and was wonder what you all thought of the forums store exhaust system; 75 - 87 X-Pipe Stainless Exhaust it is a 2.5" that runs under the transmission cross member instead of through. Would a 3" system be better or needed?

Read More | Write Comment

Pages: [1]