73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Interior & Equipment => Topic started by: Thermal Izod on October 13, 2008, 04:20:25 AM
-
For door droop, enough to lift at the handle and clunk it up and down, and enough to cause a need to slam them everytime, just to close.....do you typically just need the hinge pin? or both hinge assemblies on each door....?
-
In all my years I have never seen a hinge having to be replaced cuz of wear although i am sure if left too long you would have too....usually you can just replace the pins and bushings (or oversize bushings) and your good to go
-
It would have to be REALLY bad for you to replace the whole hinge.
-
Ever hear of a bottom hinge going bad and not the top one? The drivers bottom hinge was pretty sloppy so since i had the set from the 1st cab i replaced it on this 1 and no more play.
thanks
pat