-
I'm going to check out a TPI from a 5.7 Litre T/A. It appears that the 2 fuel line fittings have been cut off. Can these be fixed?
-
Yes you can fix the fuel lines however I hope you're getting an ECM, harness and all of the sensors with it too.
-
Here's what's included:
I know I will need a Knock sensor.....do you see anything else that may be missing?
It also comes with a steering colunm and key for the VATS security.
Thanks,Pugsy Edited by: 123 pugsy at: 10/1/06 10:16 am
-
Is that the WHOLE wiring harness. I would get the ALDL section if it isn't there. Plus the throttle cables if availible. The air cleaner and piping. Especially if it is MAF.
Is everything labeled? Chris Lucas
www.73-87chevytrucks.com
www.captkaoscustoms.com
Project Su
Jimmy 2WD Project
-
I got a lot more wiring than you see there.I got the whole fusebox and a bunch more.Some have been cut.
No throttle cable.
Its a speed density system.
Everything is not labelled,but the guy threw in a Haynes manuel for the Trans Am Edited by: 123 pugsy at: 10/2/06 5:44 pm
-
I was hoping you were going to say that there is more.
Should be able to find a cable though.
Don't need the duct if it is MAP... Chris Lucas
www.73-87chevytrucks.com
www.captkaoscustoms.com
Project Su
Jimmy 2WD Project
-
Tracking down parts is half the fun.
What's the ALDL stand for? Edited by: 123 pugsy at: 10/3/06 7:15 pm
-
ALDL = assembly line data link
Chris Lucas
www.73-87chevytrucks.com
www.captkaoscustoms.com
Project Su
Jimmy 2WD Project
-
Is that the part that you connect the scan tool up to?
-
Yep. That would be it.
Chris Lucas
www.73-87chevytrucks.com
www.captkaoscustoms.com
Project Su
Jimmy 2WD Project
-
I'm sure its in my wiring mess somewhere.There's a bunch of stuff I don't recognize. I gotta go thru it.I'm sure I'll have a few more questions on this later.
Thanks, Pugsy