73-87 Chevy _ GMC Trucks > Engine/Drivetrain
Clunk sound when in reverse
JohnnyPopper:
'You vill ansure ze question!'
Shifty:
Vee haff vays....
Captain J:
Sorry for late reply, I had some medical issues with my back, preventing me from moving or conducting what you recommended, Dr orders.
So I asked someone to check, he said all u joints are ok, he said the clunck occurred at cold and hot temp. all I see is the transmission mount need to be replaced.
So I hope it’s all that,
Next week it will be in the garage for full service and I’ll ask the mechanic to conduct a full check including {{Disconnect the rear driveline from the transfer case. With the transfer case in 2H and the transmission in park, using a pair of channel-lock pliers or similar to firmly grasp the transfer case output shaft, how many degrees of rotation stop-to-stop?}}👍🏻👍🏻👍🏻
--- Quote from: bd on November 17, 2021, 11:19:44 AM ---
--- Quote from: Captain J on November 15, 2021, 11:39:27 AM ---I did what you suggested (to put gear in N, parking brake on, check the shaft to check movement), the shaft moves from stop to stop less than 4-6mm, very minimal movement.
The transmission mount is factory original, have some cracks.
I may need to change it, but it’s not causing the loud clunk noise.
--- End quote ---
You never answered the earlier questions: Does the clunk occur only when the engine is cold and idling fast or every time the transmission is shifted into reverse, both at operating temperature and cold? Are the u-joints tight and serviceable? Any evidence of rust tracks?
Disconnect the rear driveline from the transfer case. With the transfer case in 2H and the transmission in park, using a pair of channel-lock pliers or similar to firmly grasp the transfer case output shaft, how many degrees of rotation stop-to-stop?
--- End quote ---
bd:
I understand being incapacitated. I've enjoyed little use of my hands and arms and struggled to walk for months on end. Follow your doctor's orders and recover!
From my earlier PM:
--- Quote from: bd on November 18, 2021, 11:35:04 AM ---I should explain that the recommended checks are intended to determine whether there is excessive wear concentrated in a particular part of the drivetrain. Splined shafts wear, thus accumulate clearance. It is a normal process. Wear, however, is additive. Small amounts of localized wear in the various splined connections, when added together, become significant and audible. For instance, when changing the direction of rotation in the drivetrain, such as when shifting from a forward gear or park to reverse, the small amounts of play at each splined connection can add to produce a significant amount of rotation across the full length of the rotating assembly. The result? CLUNK! So follow the recommendations and you may be able to determine if there is one or multiple sources causing the symptoms.
--- End quote ---
If you are going to take the truck to a shop you trust, just ask them to diagnose the clunk. A full-service shop should have no problem evaluating the noise and whether it should be addressed.
Best wishes for your recovery!
Navigation
[0] Message Index
[*] Previous page
Go to full version