Hello,
I CANNOT get a clutch fork to fit into my bellhousing and onto my shaft. Any thoughts or suggestions are appreciated! I have a 1987 Chevy V20 I got a few months ago. It needed a new fuel pump, fuel tank, new starter and new clutch. She (Katy) starts and runs now, but I have yet to throw her into gear... I have never replaced a clutch but I got Youtube so it seemed easy enough. Everything was hunky-dory until I went to put on the new release bearing and clutch fork, I've spent at least 4 hours trying to get the dang things on there. I have tried a variety of different auto parts stores and they keep giving me a clutch fork that is not quite the same size as the one I got off the truck. I got these numbers off of the clutch fork, 15592270, I think its the original GM part but when any auto parts stores look it up they all come back and give me the same part that doesn't fit, CF-116. I have tried telling them I got a different tranny (Tailshaft Housing Casting Numbers 15597793) but so far I haven't had any luck getting a fork that fits. I cant use the fork I pulled out because there's way too much play in it and I think that's part of the reason that the clutch I pulled off was so worn down. How can I find the correct fork?!? I attached a photo for ya'll to see how perty she is.