« previous next »
Pages: [1]   Go Down

Author Topic: 84 Sierra multi function switch removal  (Read 1525 times)

Offline 84GMCSierra

  • Newbie
  • Posts: 27
  • Newbie
84 Sierra multi function switch removal
« on: February 18, 2023, 05:42:16 AM »
Good Morning everyone. I have an 84 Sierra 2500, with a non tilt, non cruise column, and I need to replace the MF switch(Turn signal, wipers(. but can't pull the old one out to replace it. I believe I should just pull straight out to remove it, but it won't budge, and I don't want to break it. Any suggestions.
Thanks
Logged

Offline bd

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 6450
Re: 84 Sierra multi function switch removal
« Reply #1 on: February 18, 2023, 08:26:44 AM »
The column doesn't use a multi-function switch.  Each switch is separate and distinct.  To service the switches, you must remove the horn contacts, steering wheel, dust shield, and lock plate.  The switches then come out through the top of the column.
Logged
Rich
It's difficult to know just how much you don't know until you know it.
In other words... if people learn by making mistakes, by now I should know just about everything!!!
87 R10 Silverado Fleetside 355 MPFI 700R4 3.42 Locker (aka Rusty, aka Mater)

Offline dusterdude

  • Newbie
  • Posts: 67
  • Newbie
Re: 84 Sierra multi function switch removal
« Reply #2 on: February 18, 2023, 03:00:13 PM »
If you mean you need to replace the turn signal stalk,then yes it pulls out.watch some youtube videos to get some ideas on techniques to use.


Sent from my SM-G973U1 using Tapatalk

Logged
Pages: [1]   Go Up
« previous next »