Author Topic: Spindle damage/steering knuckle  (Read 2500 times)

Offline A robs 23

  • Newbie
  • Posts: 48
  • Newbie
Spindle damage/steering knuckle
« on: April 18, 2019, 08:06:46 AM »
While removing my spindle for ball joint replacement. I accidentally damaged near the bearing surface. Is this too much damage to re use?



Also, any tips on removing this steering knuckle that is so corroded i feel it may be welded onto the axel (sarcasm).

Thanks!!


Sent from my iPhone using Tapatalk

Online VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 18980
Re: Spindle damage/steering knuckle
« Reply #1 on: April 18, 2019, 11:54:06 AM »
File it and you will be okay. Looks like you mashed the stud with a hammer for the steering arm. If you are trying to remove it, you need to remove the cone washers first.
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline A robs 23

  • Newbie
  • Posts: 48
  • Newbie
Re: Spindle damage/steering knuckle
« Reply #2 on: April 19, 2019, 12:11:57 AM »
Im trying to remove the steering knuckle. I wont be upset if i cant get the steering arm off


Sent from my iPhone using Tapatalk

Online VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 18980
Re: Spindle damage/steering knuckle
« Reply #3 on: April 19, 2019, 11:33:57 AM »
Guess I looked too quickly at your picture. Hit the pickle fork with a BFH or use an air hammer. You can also strike it on the X a few times
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline A robs 23

  • Newbie
  • Posts: 48
  • Newbie
Re: Spindle damage/steering knuckle
« Reply #4 on: April 20, 2019, 03:47:19 AM »


Thanks!


Sent from my iPhone using Tapatalk

Offline 75gmck25

  • Frequent Member
  • **
  • Posts: 439
  • 1975 GMC K25 Camper Special, 350/TH350/NP203
Re: Spindle damage/steering knuckle
« Reply #5 on: April 20, 2019, 05:15:52 AM »
It looks like you got one cone washer off, but there are three more in place.  When I removed my steering arm I had to break those washers loose before the arm would come loose.  IIRC, I used an old wood chisel and penetrating oil to get under the flange of the cone washers and break them loose.  Once I had a little space under the flange of the washers, a hammer worked to break the arm itself loose.

You are also supposed to use new locking washers when you reinstall the arm.  NAPA did not have any the right size at the time, so I used Red Locktite instead.  Later on I found the right locking nuts at a hardware store, but have never gone back and installed them.

Brucd