« Last post by Mike81K10 on May 04, 2024, 08:43:36 PM »
I have seen a few different methods for measuring push rod lengths. I will do my measurements again tomorrow to double check my pushrod length and the proper geometry of my rockers arms/lifters.
« Last post by Mike81K10 on May 04, 2024, 05:37:30 PM »
My pushrods measurements came up .600 shorter than the OEM I had in my crate engine. Don't know if it is partly because of 1.6 scorpion roller rockers, the heads, or the roller engine block. Everything is different then the old flat tappet GM Block. My old pushrods were 7.800.
« Last post by VileZambonie on May 04, 2024, 07:45:06 AM »
It sounds like you installed aftermarket power window motors and switches. We can't help you unless you post the wiring diagrams and detail what you did.
« Last post by Captkaos on May 03, 2024, 02:17:43 PM »
None that I would recommend unless you are 11 feet tall and have the roof cut off the truck. We are looking into producing one but we have several that have just used modified a-trim on just one side.
1
Recent Posts