Author Topic: 81 K10 Build  (Read 31990 times)

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 18566
Re: 81 K10 Build
« Reply #255 on: April 29, 2022, 06:56:03 PM »
Looks sweet!  8)
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline Mike81K10

  • Junior Member
  • ***
  • Posts: 630
Re: 81 K10 Build
« Reply #256 on: July 10, 2022, 10:02:00 PM »
Been busy with some other things, Full suspension and steering rebuild on an 06 Dodge Dakota and some home repairs. Was trying to figure out how to repair some rounded out bolt holes in my bed that I think LineX did. Finally got some washers for a wood bed and cut out what I needed. Welded them in and still need to finish them up. Got a few pics to show the problem and my fix. I am open for any suggestions to do a better fix for the problem.

Offline Shifty

  • Junior Member
  • ***
  • Posts: 579
  • I bleed Bowtie red...
Re: 81 K10 Build
« Reply #257 on: July 11, 2022, 09:16:48 AM »
Genius!
87 V20 Standard Cab Longbed (current)

87 R30 3+3 Longbed (days of yore)

98 C2500 ext cab longbed

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 18566
Re: 81 K10 Build
« Reply #258 on: July 11, 2022, 08:19:32 PM »
Perfect
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline Mike81K10

  • Junior Member
  • ***
  • Posts: 630
Re: 81 K10 Build
« Reply #259 on: July 15, 2022, 06:50:35 PM »
Finished the two holes that were rounded out in my bed. Have to sand around them where the rubber (LineX) is at. Next I have to clean up under (bottom) of my bed and then I will be about ready to put it back on my truck. The two rounded out holes were a pain and took too much work for such a small task.

Offline Shifty

  • Junior Member
  • ***
  • Posts: 579
  • I bleed Bowtie red...
Re: 81 K10 Build
« Reply #260 on: July 16, 2022, 10:09:25 AM »
The smallest of problems usually are the biggest pain....
87 V20 Standard Cab Longbed (current)

87 R30 3+3 Longbed (days of yore)

98 C2500 ext cab longbed