AFTERMARKET TACH

[LTZ C20]

Hey FlatBlack,  I mounted mine on the column. Mine is small tho, about the size of the quarter gauges, I mounted it so that in park, it's down on the left side by the headlight switch, when you pull the shifter down into gear, the tach rotates over to just under the left blinker where it can be seen but not obtrusive.

[1986GMCSierra]

Hey FlatBlack,  I mounted mine on the column. Mine is small tho, about the size of the quarter gauges, I mounted it so that in park, it's down on the left side by the headlight switch, when you pull the shifter down into gear, the tach rotates over to just under the left blinker where it can be seen but not obtrusive.

i was goin to get this tach but i wsnt sure where to put it
its a glowshift Black 7 Color 2" Tachometer Gauge but i wasnt sure where to mount it

[LTZ C20]

Mount it on the column like I did in the pic I sent you. You can see its mounted on the part of the column that rotates with the shifter. Only held on by the bracket is came with and some black zip ties.  Been there for about 11/2 - 2 years or so.


That's a nice tach by the way.

[1986GMCSierra]

Mount it on the column like I did in the pic I sent you. You can see its mounted on the part of the column that rotates with the shifter. Only held on by the bracket is came with and some black zip ties.  Been there for about 11/2 - 2 years or so.


That's a nice tach by the way.

i will probably mount it like you had it and thanks their pretty cheap too

[LTZ C20]

Cool post a pic when you get it done. Good to know, your welcome.

[1986GMCSierra]

Cool post a pic when you get it done. Good to know, your welcome.

i will but it might be awhile i just bought a gun so i will wait a while to buy it

[LTZ C20]

Haha nice. I did too bout a month ago.

[1986GMCSierra]

Haha nice. I did too bout a month ago.

cool what did u get if u dont mind me asking

[LTZ C20]

I don't. S&W M&P Shield 40. What did you get?

[1986GMCSierra]

I don't. S&W M&P Shield 40. What did you get?

Winchester sxp black shadow 12 ga.  What strap did you use to mount the tach to your column?

[LTZ C20]

Nice! I used some black zip ties. But you could also use those stainless steel "zip ties" that are for exhuast wrap, find a way to bolt or screw it on, or go around a few laps with electrical tape lol. All depends on what you want. For me, zip ties were the easiest, plus I smack it with my knee when I get out sometimes so I can also move it back if a bump it too far.

[1986GMCSierra]

ok cool i will try zipties

[LTZ C20]

Pictures when done.

[lastwords1978]

I mounted a small tack in the pocket above the heat controls.

[1986GMCSierra]

I mounted a small tack in the pocket above the heat controls.

can you show a picture.. and what did u use to mount it?