« previous next »
Pages: 1 [2]   Go Down

Author Topic: Discharge pressure cutout switch  (Read 2524 times)

Offline MIKE S

  • Registered Users
  • *
  • Posts: 224
  • Member
Re: Discharge pressure cutout switch
« Reply #15 on: August 05, 2020, 02:43:46 PM »
Make sure you have a separate ground wire from one of the blower motor mounting screws to body ground. Remember the motor is mounted on a fiberglass housing. Make sure grounds are clean.
Logged

Offline runnergeorge

  • Newbie
  • Posts: 56
  • Newbie
Re: Discharge pressure cutout switch
« Reply #16 on: August 05, 2020, 08:03:59 PM »
That’s the first place I looked and they were all clean. And actually the shop described it incorrectly, the blower motor was blowing but the compressor clutch was not engaging. It turned out to be a simple loose connection!
Logged
Pages: 1 [2]   Go Up
« previous next »