73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Engine/Drivetrain => Topic started by: Chuck Step-a-side on June 09, 2019, 03:59:12 PM
-
So I've pulled out the worn out center bolt 350 engine and started to move some of the old parts over to the newer 350 and I notice the engine mount to motor mount bolt holes were butchered.
If I am correct, the original engine was a 305; did this need to done in order to install the 350 engine? Should I smooth out the holes and install them as-is or locate replacement engine mounts?
-
Slight differences between BBC and SBC. Is there a part # stamped on it?
-
Just get new clamshells
-
All small block in the box.
New clams sounds like a plan.
Thanks Vile-man!!