Author Topic: Found me some wonky engine mounts  (Read 1257 times)

Offline Chuck Step-a-side

  • Registered Users
  • *
  • Posts: 136
  • Newbie
Found me some wonky engine mounts
« on: June 09, 2019, 03:59:12 PM »
So I've pulled out the worn out center bolt 350 engine and started to move some of the old parts over to the newer 350 and I notice the engine mount to motor mount bolt holes were butchered.
If I am correct, the original engine was a 305; did this need to done in order to install the 350 engine? Should I smooth out the holes and install them as-is or locate replacement engine mounts?

Offline zieg85

  • Global Moderator
  • Senior Member
  • ****
  • Posts: 7543
    • 73-87 GM squarebody extended cab and conversions up to 91 R/V series
Re: Found me some wonky engine mounts
« Reply #1 on: June 09, 2019, 07:05:43 PM »
Slight differences between BBC and SBC.  Is there a part # stamped on it?
Carl 
1985 C20 Scottsdale 7.4L 4 speed 3.21
1986 C10 under construction
https://www.facebook.com/groups/248658382003506/

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 18979
Re: Found me some wonky engine mounts
« Reply #2 on: June 09, 2019, 07:11:25 PM »
Just get new clamshells
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline Chuck Step-a-side

  • Registered Users
  • *
  • Posts: 136
  • Newbie
Re: Found me some wonky engine mounts
« Reply #3 on: June 09, 2019, 07:25:11 PM »
All small block in the box.

New clams sounds like a plan.
Thanks Vile-man!!