I have an all original cab, doors, and front fenders. Both fenders have been in collisions, so I know they've been shoved rearward. I need to replace the rocker panels and cab corners. I figured I would align the original doors to use them to match the rocker to door gap. My issue is that the rear gap in the door is about 9/32", and the front gap is 0. The door was sagging by almost a 1/4", so I adjusted the bottom hinge rearward and the top hinge forward. It fixed the sag, but did nothing for the rear or front gaps. My question is this: Is it possible that the door shell is bent? Like the area around the bottom hinge pushed inward, and the area around the top hinge pulled out? Thank you!