« previous next »
Pages: [1]   Go Down

Author Topic: easy way to install turn signal switch  (Read 3471 times)

Offline 1badazz84

  • Newbie
  • Posts: 11
easy way to install turn signal switch
« on: January 11, 2009, 02:40:59 PM »
What's the easy way to install a turn signal switch by taking the column apart or is there a easy way to do it.
Logged

Offline jefferias

  • Newbie
  • Posts: 82
Re: easy way to install turn signal switch
« Reply #1 on: January 11, 2009, 03:43:30 PM »
haha  i tried to do mine and just got agitated and broke some stuff.  got a whole column from a wrecker for $20 and just replaced whole unit!  that was easier to me most defnitely
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19022
Re: easy way to install turn signal switch
« Reply #2 on: January 11, 2009, 06:41:37 PM »
yes it's easy if that's what you were asking. Remove the wheel, the lockplate, hazard button, signal stalk, canceling cam, 3 screws, and the connector. It might be easier if you loosen the column a little bit but it isn't necessary. Tie some mechanics wire around the connector and snake it out. Wrap the mechanics wire around the new one and put it in.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠ŻŻŻŻŻ'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline 1badazz84

  • Newbie
  • Posts: 11
Re: easy way to install turn signal switch
« Reply #3 on: January 16, 2009, 07:17:13 PM »
thanks for the heads up i think i could do it without getting  >:(.
Logged
Pages: [1]   Go Up
« previous next »