« previous next »
Pages: [1]   Go Down

Author Topic: Steering lock pin  (Read 1361 times)

Offline MacQueen7

  • Newbie
  • Posts: 8
  • Newbie
Steering lock pin
« on: February 06, 2021, 09:40:57 PM »
I have a standard shift tilt wheel with lights and wipers on the stalk, I replaced the turn signal switch and headlight switch.  The spring that moves the locking pin into the plate was broken.  I replaced the rack and the spring but I can’t get the pin to slide out when the key is switched to off.  Anyone have a picture of the proper install?  Or ideas?
Logged

Offline VileZambonie

  • Global Moderator
  • Senior Member
  • *****
  • Posts: 19010
Re: Steering lock pin
« Reply #1 on: February 07, 2021, 07:25:09 AM »
Sounds like you don't have it clocked correctly. Time to take it back apart.
Logged
,                           ___ 
                         /  _ _ _\_
              ⌠¯¯¯¯¯'   [☼===☼]
              `()_);-;()_)--o--)_)

74 GMC, 75 K5, 84 GMC, 85 K20, 86 k20, 79 K10

Offline MacQueen7

  • Newbie
  • Posts: 8
  • Newbie
Re: Steering lock pin
« Reply #2 on: February 07, 2021, 08:04:26 PM »
Little spring that goes in the gear for the rack wasn’t right. Found this on another thread after searching with my computer.     http://www.crankshaftcoalition.com/wiki/images/d/d6/Jazzman_Steering_Rack_Rebuild.pdf
Logged
Pages: [1]   Go Up
« previous next »