73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Engine/Drivetrain => LT/LS Swaps => Topic started by: 76highsierra on February 19, 2018, 11:25:35 AM
-
I got an amazing deal on an all aluminum 4.8L and a 4L80e plus al the Pullies and such. Anyone had experience doing the swap? I want to know the bare minimum i need to get it running then eventually I’ll start suping it up.
Sent from my iPhone using Tapatalk
-
Welcome to the site
-
I believe only the 5.3 came all aluminum. so you might have a few more cubes
-
You got an aluminum block ?
Or aluminum heads ?
-
I’m positive it is all aluminum and I’m pretty sure it’s a 4.8. It’s out of an 05 panel van connected to a 4l80 and aluminum drive shaft.
Sent from my iPhone using Tapatalk