Author Topic: 4l60e, NP241c tranny mount question  (Read 2199 times)

Offline billyt33

  • Newbie
  • Posts: 15
  • newbie
4l60e, NP241c tranny mount question
« on: September 21, 2015, 01:29:46 PM »
I just got everything in place and there is a about a 3-4 inch gap between the top of the mount and where it bolts to the tranny.  I was under the impression that i could bolt the the transmission to the original mounts.  Also I thought I might be able to use the tranny mount that originally fits the 4l60e but i believe the studs that come with it are too short.  If I didn't have to worry about how low the transfer case sits or if the front drive shaft could make it over the cross support i could make it fit.  Just wondering if there is something I'm overlooking or if there is an aftermarket support that will solve my problems. Anybody else ran into this problem? Thanks everybody

Offline Captkaos

  • OWNER and Administrator
  • Administrator
  • Senior Member
  • *****
  • Posts: 18351
    • http://www.73-87chevytrucks.com
Re: 4l60e, NP241c tranny mount question
« Reply #1 on: September 21, 2015, 10:19:09 PM »
What exactly are we working on here and what was in it prior and what is in it now?