73-87 Chevy _ GMC Trucks > Members Rides
81 K10 Build
Shifty:
The smallest of problems usually are the biggest pain....
Mike81K10:
Been working on the bottom of my truck bed for a while off and on. Was hard work stripping it down by hand - best to media blast if able (I was not), cleaned it, metal prep, and then Por15. was no rust left on it. Will apply some undercoating over the Por15 soon. Have some minor things to fix on it and will put the bed back on my truck.
Discovered another thing about the truck doing this. The wheel well liner on the truck bed is made of aluminum.
VileZambonie:
Don't use POR15 on anything. It eventually releases in sheets from the metal. What do you mean your wheel well is aluminum?
Mike81K10:
The wheel well (liner that is screwed in) inside the bed cleaned up so clean it appeared to be aluminum. Looked like it anyhow. What would you use in place of Por15?
VileZambonie:
Stick a magnet to it. It really depends on what you are going after. If it's a corrosion protection with just a black finish, chassis saver is better. Raptor liner seems to hold up good if you like that look.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version