73-87 Chevy _ GMC Trucks > Members Rides
Blazer truck buggy
JohnnyPopper:
Nice progress, looking good!
The old engine looked to have vortec heads...did you change them?
I found similar valve covers- did you do the flames?
Mike81K10:
Should have fun with the build, enjoy! Look forward to pics along the way.
bluevan:
The old engine I believe is a GM "Targetmaster" crate engine from the 70s with Gen 1 #3998993 heads that are (I think) are original to it. The block has # 3970010 stamped on the back and #K0820TXB on the pad. It has 4 bolt mains and unknown internals. It was pretty clean inside when I took it partially apart so I am just going to drop it in and see what happens. I am trying to do this cheap since I blew the budget on the other project truck. I have spent about $400 so far on this thing and it looks like I need a $100 Xcase adapter.
Those $36.99 tall valve covers are off the shelf from Summit. They seem to be nice quality and I am happy with them.
Joel
Captkaos:
This is a pic of one on the forum. it isnt 4x4 but it gives you an idea.
Below is one from a build thread on pirate4x4
bluevan:
When I finally cleaned the partially stripped down engine so it was ready to paint (such a treat) I searched up some tips and I got guided into going over it with heat before I laid on the paint. So I took a torch and went over the the block and heads and it seemed to boil out any crap that was left from cleaning. Work down and you can see it coming out. After I final wipe down I sprayed it with rustoleum "heavily rusted metal" primer and then a $12 can of chevy orange from Autozone. Heard its better to brush it on, but we will see how it lasts.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version