All Classified forums require a Site Supporter subscription. It is only $25 per year and you can buy and sell whatever you like on the forum. To become a Site Supporter, go to Your Profile and select "Paid Subscriptions."
You might wind up with a new tank I've had a couple of older vehicles where the filter would clog every 25-50 miles and I had to replace the tank It had so much rust and dirt in it I used the clear plastic 3/8 filters so I could see what it was catching A new tank from rock auto is less than$100
Very common especially if there's junk in the tank or bad gas. Where and what kind of fuel filter are you running?
Any suggestions as to what type of filter I should purchase? If these aren't doing the job I hate to buy another that doesn't do the job.....thanks for any advice,ricky
Quote from: VileZambonie on November 30, 2017, 08:53:27 PMVery common especially if there's junk in the tank or bad gas. Where and what kind of fuel filter are you running?very common when you put junk on your intake manifold.
Quote from: Willy Lee on January 08, 2018, 10:15:55 PMQuote from: VileZambonie on November 30, 2017, 08:53:27 PMVery common especially if there's junk in the tank or bad gas. Where and what kind of fuel filter are you running?very common when you put junk on your intake manifold.Are you say edelbrock carbs are junky? I've heard that they were pretty good. Does Carter still make carburetors? Those are good, right?Meh I found the best way to tune an Edelturd is with a 3lb sledge. I guess if you like low performance and mediocre drivability then I guess they are ok. It’s a shame that the Weber logo is on them kinda cheapens that brand a bit.Sent from my iPad using Tapatalk
Quote from: Big Chip on January 08, 2018, 10:27:19 PMQuote from: Willy Lee on January 08, 2018, 10:15:55 PMQuote from: VileZambonie on November 30, 2017, 08:53:27 PMVery common especially if there's junk in the tank or bad gas. Where and what kind of fuel filter are you running?very common when you put junk on your intake manifold.Are you say edelbrock carbs are junky? I've heard that they were pretty good. Does Carter still make carburetors? Those are good, right?Meh I found the best way to tune an Edelturd is with a 3lb sledge. I guess if you like low performance and mediocre drivability then I guess they are ok. It’s a shame that the Weber logo is on them kinda cheapens that brand a bit.Sent from my iPad using Tapatalk