73-87 Chevy _ GMC Trucks > 4 Wheel Drives

Removing Selectro Hubs

(1/1)

Rcf:

I am having a rather difficult time (stumped actually) getting the Selectro front hubs off in order to replace the rotors on my '83 K30.  Would appreciate any insight into what I need to do.

I did manage to remove the three screws and get the cap off, but that is where the road ended.

Any ideas?

VileZambonie:
Sounds like you didn't get very far. Did you read the procedure in the manual? http://www.73-87chevytrucks.com/techinfo/7387CKMans//Service/ST_330_83_1983_Chevrolet_Light_Duty_Truck_10_to_30_Service_Manual.pdf

VileZambonie:
Also, depending on which ones you have on there and which axle is installed, you can look up the instructions on the hubs for assembly/disassembly, and then just follow the procedure for the wheel bearings and rotor swap.

Rcf:

Thanks, Vile.  I checked the manual, but did not find anything useful.  There is a lot of useful information in there that will be beneficial, though.  Perhaps a picture is indeed worth a 1000 words.



This is the hub and I have removed the metal spring steel ring that looked like it was holding things in.  No such luck.  I cannot see anything else that is removable.

VileZambonie:
Follow the instructions for the hubs and then follow the instructions for the wheel bearings and races.

https://milemarker.com/wp-content/uploads/2017/11/11034-instructions-scan.pdf

Navigation

[0] Message Index