Author Topic: trans seal  (Read 2137 times)

Offline barneyb1

  • Newbie
  • Posts: 8
trans seal
« on: December 29, 2006, 10:53:00 PM »
how hard is it to replace the rear seal on a auto transmission


Offline Lt.Del

  • Andy aka:SgtDel
  • Senior Member
  • ****
  • Posts: 3864
  • DelbridgePhotography.com
    • www.delbridge.net
Re: trans seal
« Reply #1 on: December 29, 2006, 11:06:00 PM »
The seal around the yoke????  if so, it is simple.  Take drive shaft out and pop the old one out with screwdriver or the like.  Use a block to pop the new one on to ensure and even press....tap w/ hammer. Be sure to rub  a little fluid around the rubber part of seal prior to putting her in so it won't be eaten up w/ friction initially.  

SgtDel
aka "Andy"

www.delbridge.net

1979 Big 10 383 stroker
1991 Blu 'Burb 3/4 ton 4x4

Edited by: SgtDel  at: 12/29/06 11:07 pm