73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Body, Glass & Paint => Topic started by: murraygmc on December 07, 2008, 08:24:21 pm
-
OK my ol lady is getting me a driver side finder 4 Christmas an the inner finder Wells so my question is how much do i have to remove to do the job and how hard will the job b thanks
-
You will need to take out the grill, head lights. head light door, and the stainless trim on the front edge of the side you are replacing. After that there is a few 9/16 heads and a bunch of 1/2 head bolts.One underneath at the front of the rocker, one above the top door hinge, one right near the hood hinge. There are 5 or so down the radiator support inside under the hood. Then a few beside the head lights.Then there are some all the way around the wheel opening of the fender. There are three along the front edge of the inner fender, and two in the rear of the wheel well for it.
Hope the helps you out.
-
ya thanks is there any thing i need to take off in guessing the charcoal can what about the power steering and such thanks agan
-
Power steering should not have any problems. You will need to unbolt the charcoal canister to get to the bottom inside bolts. The battery and battery tray on the right hand side need to come out.
-
Power steering should have any problems.
I am sure Blazin meant to put a "not" in the middle.
-
cool sounds like im in 4 a lot of unbloting lol bring it thanks!
-
it kinda sounds like a lot of work guess i shuld whait on the pas side b4 i start hu..