73-87chevytrucks.com

General Site Info => General Discussion => Topic started by: heyharris1 on March 19, 2009, 09:22:39 pm

Title: need help trying to locate a part
Post by: heyharris1 on March 19, 2009, 09:22:39 pm

hello, what i am trying to find is a clutch fork pivot ball. i have seen all kinds but there different than mine. this one has predrilled holes so it can be lubed from a zert fitting. its off a 1986 chevy c30 1 ton 454 with a sm465 tranny. i was orginally going to switch to an auto but with the economy could not afford to right now and need the truck on the road so i figure i would just replace the shot clutch. got the new clutch in and ready to go. had to get a new clutch fork also. everything was going good but no auto part stores i have found even have a link to this perticular one. any help in the right dirrection would be appreciated.
(http://c4.ac-images.myspacecdn.com/images02/83/l_ea9cd49730524d24a7a8278c3710d477.jpg)
(http://c1.ac-images.myspacecdn.com/images02/79/l_d7be53c76bab40d89be31d4c7940a0c4.jpg)
(http://c3.ac-images.myspacecdn.com/images02/85/l_e8ee883741b44978a188e0e460b1b892.jpg)
thank you
jim

Title: Re: need help trying to locate a part
Post by: VileZambonie on March 19, 2009, 10:05:23 pm

Dealer or just weld and grind

Title: Re: need help trying to locate a part
Post by: heyharris1 on March 19, 2009, 10:15:27 pm

thats were im going to try tomorrow after work (cross fingers)

Title: Re: need help trying to locate a part
Post by: Blazin on March 20, 2009, 05:31:26 am

Is the grease fitting the only difference? If so drill and tap one without it for a fitting!

Title: Re: need help trying to locate a part
Post by: heyharris1 on March 20, 2009, 05:55:51 pm

found it at the dealer for 17.90 be here tuesday, hopefully get the tranny in then also and be driving by thursday :-)