73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Engine/Drivetrain => Topic started by: a66boo on April 19, 2009, 01:23:09 AM
-
I recently acquired a 12 bolt 3.40 gov-loc posi rear from a 1979 1/2 ton shortbed that I want to bolt in my 1985 1/2 ton that has it's original open 10 bolt rear... This leads me to the u-joint dilemma where the original 10 bolt yolk was larger than the 12 bolt. Does anyone know either the physical measurements for the proper u-joint size that bolts into the 12 bolt so I can try to fins a conversion joint to adapter? Or better yet happen to know a part number for the conversion u-joint!?
Thanks for your time...
-
i don't know any joints numbers but what i did at autozone when i worked there bring both joints or get them to get them from behind the counter and then get them to find a similar joint with two ends that match the size and leanth of the 85 and the other two that match the 79
-
Here's one I used http://forum.73-87chevytrucks.com/smforum/index.php?topic=7334.75
-
Thanks Guys!! I searched and searched, apparently I don't search well!
Vile, Thanks a million!!
-
Just for clarification and assistance to possible future folks searching on this subject.....
The Corporate 10 bolt 8.5 inch rear on my 1985 1/2 ton 4x2 uses a 3R size joint on the drive shaft and yolk.
The 12 bolt from a 1979 1/2 ton 4x2 uses a 1310 size joint on the yolk.
A conversion u-joint would be available: Here's a source
http://www.dennysdriveshaft.com/p466_1310_to_gm_3r_s44_series_combination_u_joint...spicer_grease.html
Or
http://www.theujointstore.com/33131.html