73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Blazers/Jimmys => Topic started by: exodus138 on May 11, 2009, 07:18:09 pm
-
i recently purchased a 79 jimmy and the rear window switch is missing i found it in a junk box in the rear i need to figure how to wire it. the switch has 3 prongs there are only 2 wires coming from the rear window a blue and a white one. the prongs on the back of switch are in uniform alignment with the center raised higher im guessing its in nutreul. do i hook the two wires up and leave the center empty or do i run a ground to the center wire? all help will be appreciated
-
Piece of cake
(http://i6.photobucket.com/albums/y228/Sabaka454/rearwindow.gif)
Click this link to view the full size
Click Here (http://i6.photobucket.com/albums/y228/Sabaka454/rearwindow.gif)
-
so ihook center wire to a pink comin from fuse block? i'm horrible with diagrams
-
Yes the pink wire is protected by a ckt breaker in the fuse block.
-
i searched through this mess called wiring... no pink wire comin from fuse panel... not surprised everything is split probably going to need a new harness. messy lazy previous owners! short on cash right now can i run a new wire to it? if so where on the panel should it run to?
-
Do you have the rear power window circuit breaker in your fuse panel?
-
how can i find it? do you know where it's located?
-
In the fuse box. Take a picture of your fuse box and post it.
-
humm the only thing i can think of is hard wiring it like an acc switch not really sure i was thinking about putting eletric back window in my 77 blazer just wire it up with a some wire that has a fuse built into it if you will get what i mean by this but it sounds good to me haha all it is ...is and up /down switch with power going to it
-
???