73-87chevytrucks.com

73-87 Chevy _ GMC Trucks => Interior & Equipment => Topic started by: Armor on May 27, 2009, 05:56:04 pm

Title: painted the floor
Post by: Armor on May 27, 2009, 05:56:04 pm

Well i finally finished the floor Blue yesterday, using KBS rust paint, and a bit of elbow grease:

This is the Frame Coater Kit:
(http://i638.photobucket.com/albums/uu103/armor64/Primer%20Floor/DSCF0410.jpg)

STARTING POINT
(http://i638.photobucket.com/albums/uu103/armor64/Primer%20Floor/DSCF0427.jpg)

Using the rust killer step in the frame coater kit i nabbed, it looked as if it was actually killing the rust and turning it white, which was cool to watch
(http://i638.photobucket.com/albums/uu103/armor64/Primer%20Floor/DSCF0420.jpg)

then it was paint brush time, and 2 coats later it was all shiny again
(http://i638.photobucket.com/albums/uu103/armor64/Primer%20Floor/DSCF0429.jpg)
(http://i638.photobucket.com/albums/uu103/armor64/Primer%20Floor/DSCF0441.jpg)


all in all it works great, and when they call it hammer tough(tough to get through) i agree, my buddy dropped a toolbox on the floor at the little ridge in the center of the passenger side, and it made a dent about 1inch down..... and the paint when with it lol, instead of cutting or chipping.
now its only sound insulation/deadening and put it all back together

Title: Re: painted the floor
Post by: oldwhity on May 27, 2009, 09:40:18 pm

Looks good!

Title: Re: painted the floor
Post by: infamouschevy on May 27, 2009, 09:40:31 pm

where did you buy the meterials at how much did u spend ive ben thinkin of doen the same thing

Title: Re: painted the floor
Post by: Armor on May 27, 2009, 09:48:34 pm

i got it from syncon, a company up here in ontario, its north of toronto, they are the only ones up here i could get it off of, and the frame coater kit was 55$, came with all the stuff in the pic. they actually sent me a gas tank repair kit on accident, but the next day they had at my door the correct frame one, and told me to keep the other for the hassle. All in all great product and people

Title: Re: painted the floor
Post by: 80stepsideguy on May 28, 2009, 03:22:06 am

I used this exact stuff on the frame of my truck and it is strong stuff. I rolled it on and it flows out so nice .I even used it on the front engine cradle crossmember on the inside and it looks just as good on the outside as is in the insdie...

(http://i205.photobucket.com/albums/bb112/ramsportguy/cradle1.jpg)

(http://i205.photobucket.com/albums/bb112/ramsportguy/cradle3.jpg)

thanks
pat