73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => 73-87 Chevy & GMC Trucks => Topic started by: BigBadJohn on August 31, 2009, 07:38:33 pm
-
1/8" steel plate and 3/4" angle iron
Dozen tapped 1/4-20 holes
I was tempted to make it out of 1/4" diamond plate steel but that woulda been a little over the top :o
(http://i182.photobucket.com/albums/x78/BigBadJohn79/Truck/100_5119.jpg)
(http://i182.photobucket.com/albums/x78/BigBadJohn79/Truck/100_5117.jpg)
And here it is painted, wired, and reinstalled
(http://i182.photobucket.com/albums/x78/BigBadJohn79/Truck/100_5122.jpg)