73-87chevytrucks.com

73-87 Chevy _ GMC Trucks => Body, Glass & Paint => Topic started by: chronos on March 19, 2010, 02:37:28 pm

Title: Drilling hole for power doors
Post by: chronos on March 19, 2010, 02:37:28 pm

Another question. I'm going from manual to full power doors
and have to drill the hole in the door post.
Does the front fender have to come off to do this?
It's hard for me to tell.....hope the answer in NO....lol

Title: Re: Drilling hole for power doors
Post by: Blazin on March 19, 2010, 03:44:56 pm

The doors only need to be off. If you look close you will see two little dimples in the a pillar post. Drill them for the screws that hold the boot. Drill a bigger hole for the wires to run through.

Title: Re: Drilling hole for power doors
Post by: chronos on March 22, 2010, 01:21:19 pm

Thanks Blazin.....great news

Title: Re: Drilling hole for power doors
Post by: VileZambonie on March 22, 2010, 05:48:11 pm

I'll be doing this on a door tomorrow