73-87chevytrucks.com
73-87 Chevy _ GMC Trucks => Interior & Equipment => Topic started by: bidda-boy on September 10, 2010, 09:23:00 pm
-
Ive got no dash lights on new project truck just acquired. Fuse is good any suggestions would be appreciated Thanx biddaboy
-
Oh sorry its a 1987silverado 2wd
-
Do the gauges work?
The obvious thing to check is the headlight switch, is the knob turned all the way over (to the right as I recall)?
First thing first, check the fuses. Then check wiring connections behind the gauge panel, then check printed circuit board.
-
Yes all gages work just no lights,rotated the rheostat on light switch no difference
-
If your bulbs are good and fuses are the problems could be headlight switch or printed circuit board. you can test them both with a volt tester make sure your switch is getting power but I cant tell you off hand which wire is the hot wire for the bulbs. And like everything I said has been said before test the printed circuit board
-
My dash lights did not work on the last truck I got. I took apart and checked all the usual suspects, including the printed circuit board. It ended up that I needed to clean the corrosion off the back of each dash light and they all worked perfect after that. Like I always say, check the easiest things first and save some headaches.....Tom